3D Printer RAMPS 1.4 Controller Control Panel for Reprap Mendel Prusa Support for Devlepment Board

Introduction

Brand new and high quality.
Fully assembled & tested, no soldering required.
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
The modular design includes plug in stepper drivers and extruder control electronics on an MEGA shield for easy service, part replacement, upgrade-ability and expansion.
A number of expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
Size: 11.5cm x 6cm / approx. 4.5in x 2.4in.