1.

Surfaces must be clean, dry and thoroughly roughen.

2.

Remove caps, pierce end of tubes. Squeeze equal amount of resin and hardener from each tube. Ratio 1:1.

3.

MIX THOROUGHLY until consistent crystal clear color mixture.

4.

Apply to the surfaces to be repaired or joined together.

NOTE:
1.Not recommended to use above 100°C. If temperature is below 15°C, the hardening time is considerably longer.
2.If it is used under low temperature, it takes a longer time to cure; or if the hardener is hardened before using, soften it by hair drier for few minutes