Climbing Car Model: After the throttle back in the middle, automatic brake motor.(When the motor is forward rotation, pull back the throttle, motor reverses immediately)
No Brake Model: After the throttle back, the motor can rotate by inertia.(When the motor is forward rotation, pull back the throttle, motor reverses immediately)
Specifications:
- UBEC: 5v 2a(power for receiver and servo)
- Weight: 65-70g
- Signal Connector: wire length about 20cm
- Control Switch: wire length about 20cm(switch size: 1.2cm*1.2cm)
- Power Connector: xt60 or without(optional)
- Motor Connector: xt60 or without(optional)
- Dimensions: 5cm x 3.6cm x 2.3cm
120A :HC960A(in short: 960A)
- Working Voltage: 10v-32v(lithium battery 3s-6s) support 24V battery.
- Continuous/Peak Current: 150A/960A forward, 150A/960A reverse.
- Wire: power wire and motor wire 12AWG-100mm
- Size: 5 CM * 3.5 CM * 2.9 CM
- Support Motor: brush motor(540/550/775/795/D848) etc. can connect with 2 motors which rotation less than 10000rpm
Note:
It is the motor's own speed, not the speed after the gearbox.
when the motor is 16V, 10000 rpm, connect with 16v battery, can connect with 2 motors. Can't connect with more than 16v battery
Light Status:
After esc power turned on, the indicator light on, and blink one time, after remote control stroke set, the light will flash one time again.
After the signal loss signal, the indicator flashes rapidly.
The method of quasi-standard travel: When the stroke of the remote control reaches the maximum, esc power turned on, the indicator light on, and blink one time, then insert the signal into the corresponding channel of the receiver. Wait a few seconds for the indicator light to flash twice, then set the remote control stroke, the indicator light flashes three times
Package includes :
1xESC