Programe Card for ELE E-Hobby-B Seires 12A, 20A, 25A and 30A Brushless Speed Control

Not suit for 40A above Fly series ESCs.

Dimension: 41 x 42.5 mm  

1. Brake mode
   - Brake on
   - Brake off
2. Motor Timing
   - Timing low : Best for or motors with 2, 4 and 6 pole inrunner motors. It can provide the maximum efficiency.

  - Timing high : we recommend this setting for outrunner and brushless motors with more than 6 poles.

 3. Throttle Curve
   - Linear :-When the throttle is in the middle position, it equals 60% of the maximum RPM. It is for models needing mild throttle response such as F3A acrobatic airplane, 3D acrobatic airplane etc.

    -Logarithmic : When the throttle is in the middle position, it equals 45% of the Watts and 80% of the maximum RPM. For models that need sensitive throttle controlling, such as racing airplanes, powered gliders, remote controlling boats or cars etc.

4. choice for batteries
   - Nixx : Ni-Cd & Ni-MH

   - Lixx : Li-ion & Li-Polymer)

5. Cutoff Voltage
   -  high :  Ni-Cd & Ni-Mh  setting for cut off is 0.9v for each cell.
                      Li-ion & Li-Polymer  setting for cut off  is 3v for each cell.
   -  low :   Ni-Cd & Ni-Mh  setting for cut off is 0.7V for each cell.
                     Li-ion & Li-Polymer setting for cut off is 2.7v for each cell. *

6. Throttle Cut
   - hard : Power will be cut off from speed controller instantly when the voltage of battery reaches the cutoff 
          voltage.. 
   - soft : Power will be gradually lowered leading up to when the voltage of battery reaches the cutoff 
          voltage.. 
*factory default.

Program card using:

- please set all the 6 plastic caps on the program card to definite(for choice of different function) positions.

- Plug JR connector to definite position.

- Connecting the speed controller to motor

- Please connect the ESC with OPTO to 4-6V

- Connect with the power

- You can hear "beep"

- Cut off the power

- Cut off the program card.

- plug JR connector to definete channel of the receiver