Our AriesRc.gr uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.

Cookies Settings
> >>3D Printer z-probe Touch Auto Leveling Sensor Touch for Improve Printing Precision

3D PRINTER parts

Manufacturers

INFORMATION

3D Printer z-probe Touch Auto Leveling Sensor Touch for Improve Printing Precision View larger
Previous Next

3D Printer z-probe Touch Auto Leveling Sensor Touch for Improve Printing Precision

(SKU): FYSETC-Leveling-Sensor

3D Printer z-probe Touch Auto Leveling Sensor Touch for Improve Printing Precision

More details

In stock

20,00 € tax incl.

More info

HTB1kSwVmvBNTKJjSszbq6yFrFXaX

3D printer z-probe Touch uses the same servo signal which used in previous servo line.

 
■ Solenoid Push-pin Up ➡ servo signal 90Degree(ex : M280 P0 S90 ) 
 
■ Solenoid Push-pin Down  ➡ servo signal 10Degree(ex : M280 P0 S10 )
 
■  Manual Self-test ➡ servo signal 120Degree(ex :  M280 P0 S120)
 
■ Alarm Release ➡ servo signal 160Degree(ex : M280 P0 S160)
 
 
 
※  3D printer z-probe Touch can be operated in the following condition.
 
  - One I/O (PWM or Software PWM) for control 
 
  - One I/O for Zmin
 
  - GND and +5V  power
 
 
However, Firmware updating might be needed on a case.
 
If you use this on an Anet A8 then you need to cross over the YELLOW & BLUE wires. Couldn't figure out why it wouldn't work until I read the head unit. The Yellow is the endstop and the Blue is the pwm input, I just cut them and reversed them.
Voltage5V
Current15mA
Maximum(Peak)Current 300mA
ColorSemitransparent Black
Cable Length150mm
Weight0.35 oz(10g)
Wiring3Pin:Black(-,GND)
Red(+5V)
        Blue(control Signal)
2Pin:Black(-,GND)
  Yellow(Zmin)