Universal Metal Motor Pinion Gear Puller Remover W010 for Walkera RC Drone Rc Helicopter

Walkera Gear Puller Puller Gear Remover Original Genuine Model Aircraft Tool Note: Some motor gears are added with high-strength industrial glue, which may not be removed. The gear extractor is effective for small and medium-sized motors. If the individual motor cannot be removed, do not use forcefully, which will cause the thimble to bend and deform the gear extractor. , Deformation and bending caused by improper force or excessive force does not support return and exchange! The Walkera standard set includes 0.9mm (cylindrical), 1.75mm (semi-circular), 1.75mm (cylindrical), 1.9mm (cylindrical), 2.8mm (semi-circular) Plastic bag packaging: 65g How to use the gear puller: 1) Please select needles according to the size of the motor shaft diameter. Do not use a needle that is too small to push against a motor with a large shaft diameter to pull the gear, otherwise the thimble will be broken. The glued gear must be heated first to melt the glue. Take the tooth extraction again! ! 2). Choose the thimble of the gear puller you need, install the gear puller rotating rod, and tighten the screw (note: the thimble with platform, the screw should not be too tight). 3). Install the gear puller rotating rod into the gear puller bracket. 4). Install the moving plate of the gear puller. 5). Clamp the motor into the moving plate of the gear puller, and move it until the motor shaft is aligned with the gear thimble. 6). Rotate the lever of the gear puller in a clockwise direction at a constant speed, and pull out the motor gear. 7) Gears with a maximum outer diameter of 11mm and a tooth height within 12mm can be pulled.