Το AriesRc.gr χρησιμοποιεί cookies για να προσφέρει καλύτερη εμπειρία χρήστη και σας συνιστούμε να δεχτείτε τη χρήση τους για να απολαύσετε πλήρως την πλοήγησή σας.

Flight Controller

Κατασκευαστές

Πληροφορίες

Ardupilot APM 2.8 Flight Control Board Bend Pin with Protective Case for RC Multi Rotor Drone

Ardupilot APM 2.8 Flight Control Board Bend Pin with Protective Case for RC Multi Rotor Drone

Περισσότερες λεπτομέρειες

Διαθέσιμο

100,00 € με Φ.Π.Α

-20,00 €

120,00 € με Φ.Π.Α

Άλλες πληροφορίες

Description

Note:Now the latest Mission planner 1.3.76 has bug ,it can not calibrate Accel for APM,Waiting for the official fix of this bug, please use version 1.3.74.

https://firmware.ap.ardupilot.org/Tools/MissionPlanner/archive/MissionPlanner-1.3.74.msi

  • Introduction:

  • This is the new APM 2.8 autopilot module. The sensors are exactly the same as with APM2.6.

  • The APM 2.8 is a complete open source autopilot system and the bestselling technology that won the prestigious 2012 Outback Challenge UAV competition. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints. Available with top or side connectors.

  • This revision of the board has no onboard compass, which is designed for vehicles (especially multicopters and rovers) where the compass should be placed as far from power and motor sources as possible to avoid magnetic interference. (On fixed wing aircraft it's often easier to mount APM far enough away from the motors and ESCs to avoid magnetic interference, so this is not as critical, but APM 2.6 gives more flexibility in that positioning and is a good choice for them, too). This is designed to be used with the 3DR uBlox GPS with Compass (see option below), so that the GPS/Compass unit can be mounted further from noise sources than APM itself.

  • Features :

  • Arduino Compatible

  • Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer

  • Onboard 4 MegaByte Dataflash chip for automatic datalogging

  • Optional off-board GPS, uBlox LEA-6H module with Compass.

  • One of the first open source autopilot systems to use Invensense's 6 DoF Accelerometer/Gyro MPU-6000

  • Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively.

  • Note:

  • if use apm2.8 without internel compass, you should add externl compass, and the type of  externl compass is HMC5583 or HMC5983.

GET THE LOOK✨:APM2.8 APM 2.8 flight controller board apm 2.5 2.6 upgraded with internal compass for RC Quadcopter Multicopter Ardupilot
PRODUCT PROPERTY:✨ 1: Rohde offer amazing our product.Materials like composite material are used in making our product.Product original from cn(origin).
✨ 2: The for vehicle type is airplanes.The recommend age of our product is 7-12y.The technical parameters of our product is value 6.
✨ 3: The wheelbase of our product is bottom plate.

PRODUCT DESCRIPTION:1. Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer. 
2. Onboard 4 megabyte dataflash chip for automatic datalogging. 
3. Optional off-board gps, ublox lea-6h module with compass. 
4. Atmel's atmega2560 and atmega32u-2 chips for processing and usb functions respectively. 

REASONS TO BUY:✨ Ardupilot flight controller: the ardupilot flight controller has been designed to guide you through your route in any direction. get this board done! 
✨ Board: the board is made of high-quality pvc material, which is more durable and wear-resistant. it can be used for a long time. 
✨ Intelligent control: the apm flight controller has an intelligent control panel, which can automatically adjust the direction and speed of the flight. 
✨ Easy installation: the controller board is easy to install and disassemble. it can be installed in a few seconds, which is convenient for you to use. 
✨ Ultra light and slim fit: this controller board is ultra slim fit for most compass users. it can be easily put into your backpack or handbag without taking up too much space. 
✨ Recommended seller: it is recommended to use the board when shipping to the u.s. based customer service team, if you have any questions or concerns, please feel free to contact us and we will provide timely response as soon as possible. 
✨ This is the new apm 8 autopilot module. the sensors are exactly the same as with apm. 
✨ One of the first open source autopilot systems to use invensense's 6 dof accelerometer/gyro mpu-6000. 

WARM TIPS:Attention: 
If use apm8 without internel compass, you should add externl compass, and the type of  externl compass is hmc5583 or hmc598. 

RELATED INFO:✨ Apm 2.6: apm flight controller board for all your ardupilot needs. you can get the most out of every module in the world. 
✨ Ardupilot apm 2.8 flight controller board: the ardupilot flight controller board gives you more control over the distance and direction of the flight, without compromising your safety. 

Package includes:
1 x APM2.8 Flight Controller With Case (No Built-in Compass)
1 x Cable